To get to this page, go to Settings → Local Mail → LAN Forwarding → Queue Status

 

This page shows messages in the LAN Forwarding queue which are waiting to be sent on to other SMTP mail servers.

The four columns in the table show:

•Sender - this is the email address of the person who sent the message

•Target Server - this is the name/IP address of the mail server where the message will be sent. This is obtained from the configuration entry which put the message into the LAN Forwarding Queue

•Recipient(s) - this is a list of email addresses which the message has to be sent to. Note that if the message has been sent to some of the original recipients, only the remaining recipients will be listed here

•Subject - this is the message subject. This is useful for finding a particular message, but not used in the actual LAN forwarding process itself

The list is limited to 100 entries, so if there are more than 100 entries, only the first 100 will be displayed.

You can delete messages from the queue by checking the box to the left, and pressing the Delete Messages From Queue button. Note that you cannot remove any messages which are being sent at the same time as you press the button.

If you press the Pause LAN Forwarding button, then VPOP3 will pause the LAN forwarding background tasks until you press the Resume LAN Forwarding button (which is hidden unless it is paused).

To refresh the list, press the Refresh Queue View button.